After your equipement gets fried is the wrong time to realize you need a surge protector. It’s too late at that point. Fortunately, you can spend a very reasonable amount of money to put an almost literal firewall between your expensive (and cheap) electronics and the electrical coming in from a wall socket. A surge protector throws itself into the line of fire, sacrificing its components again and again so that your devices stay functional.
Here are our top picks in several categories. If you’re not sure what type of protection you need, scroll down a bit further and we’ll help you decide.
Updated July 18, 2022 to add a link to our Meross Smart Wi-Fi Surge Protector review. We can’t give this appealingly inexpensive smart outlet strip a high recommendation because the manufacturer hasn’t provided us with specifics related to its power-handling capabilities or any indication of independent third-party electrical certification from the likes of Underwriters Laboratory or Intertek.
TP-Link Kasa Smart Wi-Fi Power Strip (model HS300) — Best smart surge protector
Six switched AC outlets that can be programmed with complex schedules
Includes an “away” mode for simulating someone present in a home or office
Works with Amazon Alexa and Google Assistant
Outlets can be combined in scenes with other Kasa Smart devices
No manual in the box, not even a tiny one
Power cord is slightly too short for versatile placement
TP-Link really has produced the ultimate surge protector. All six of its outlets can be controlled and scheduled individually—and with a polished mobile app, no less—and you can also control any of them with voice commands. There are three USB charging ports here, too. As you can see from the link above, the model HS300 has been selling for much less than its $79 MSRP. The same is true of TP-Link’s smaller Kasa Smart model KP303. It has three outlets and two USB charging ports and was going for $25 on Amazon at the time of this writing.
Charg puts nearly every charging and protection feature in a single power strip: Replaceable surge protection, USB charging, a long cord, and cable management. The feature that sets this product apart from the crowd is the fact that you can buy a new surge protection cartridge when it wears out. All surge protectors will wear out over time. When that time comes with almost any other surge protector, you’ll need to toss it in the garbage. Not this one. We also dig that all the plugs can be hidden on the underside of your desk, and that cord is super long. As much as we like it, there are some areas that could use improvement: The outlets on the two strips won’t accommodate oversized wall warts without blocking an adjacent outlet, for instance.
Belkin’s 12-Outlet PivotPlug Surge Protector (BP112230-08) won’t cut off power when it can no longer protect your devices, but it does offer low clamping voltage (330V on all legs). This is a very flexible and adaptable surge protector, with an eight-foot cord and both protection and ground-fault indicators. Unlike TP-Link’s product, Belkin’s device has been selling for more than MSRP lately.
Don’t make the mistake of dismissing the Philips model SPC3064WG/37 surge protector as a mere power strip. Sure, it doesn’t offer much in the way of flashy features, but it will protect whatever hardware you plug into it, and it’s in the rare class of devices that will shut off when it can no longer fulfill that mission. The APC product below does the same and it has twice as many outlets, but it costs more than twice as much.
APC’s SurgeArrest Performance P12U2 is our new favorite surge protector that automatically cuts power when protection ends. It’s a 12-outlet model—two more than our previous pick had—and it has two super-convenient fast-charging USB ports. The Tripp Lite TLP1008TEL is another good choice, but it doesn’t have the USB charging ports and it has two fewer outlets. We liked the TLP1008TEL a lot better when it was selling for much less than APC’s product.
If you place tremendous value in industrial design, the Austere VII Series surge protector is the most attractive device in this category. With a brushed-aluminum enclosure, polished beveled edges, and a braided-fabric power cord, we haven’t seen anything else that comes close in terms of its industrial design. And it’s not just pretty, this surge protector has all the features you’d want to protect your expensive electronics, plus a USB-C Power Delivery port. Whether you find that combo worth $230–$30 more than when we first reviewed it–is up to you.
We considered several common factors for three scenarios: a home-entertainment system, such as a TV, disc player, streaming media box, and receiver system; a home office or cubicle with a desktop computer and peripherals, including monitors and hard drives; and an on-the-go option, if you want to travel with a multi-outlet strip that also gives you piece of mind, especially in hotels and conference rooms, where you don’t know what kind of power will be provided.
We evaluate these features in our surge protector reviews:
Does the surge protector continue to provide power when its clamping capability has burned out? (See the next section for an explanation of precisely what that means.)
How easy is it to plug in both regular 2-prong and 3-prong cables intermingled with various kinds of USB adapters and wall warts?
What’s the ratio of cost to features and outlets?
Does it offer advanced features, such as USB charging?
For travel models, how many outlets does it have while remaining compact and versatile, in addition to everything above?
Features you typically won’t find in surge suppressors such as these are alarms or networked intelligence to alert a computer (and manage a controlled shutdown), or act as an Internet of Things device, to warn about electrical anomalies or provide a status report. For that, you’ll need to step up to an uninterruptible power supply (UPS), which combines a continuously charged battery backup, power conditioning, and surge protection. Those cost from a little to much more.
What does a surge protector do?
These reviews are of surge protectors designed for a home office or a home-entertainment system. Such power mediators have a single function: keeping voltage from exceeding a certain rated level, beyond which equipment can blow a fuse, burn out its power supply, or completely fry its circuitry beyond repair. The surge protector takes a hit instead of your hardware or A/V system, and it could potentially save you hundreds to many thousands of dollars, depending on what you have connected.
You want to make the modest investment in a surge protector for the same reason you want to have a backup of your data: because there’s no going back after an adverse event. Getting ahead of a problem that may be unlikely but not improbable saves you from the enormous consequences if it occurs. (You do have multiple backups of your data, right?)
The electrical grid wasn’t designed for electronics, and surges and spikes used to be more regular and higher, as they didn’t affect electric motors. That’s changed dramatically over several decades, as utilities have cleaned up what’s delivered to homes and buildings. Depending on the age of a utility’s systems and how frequently lightning strikes occur, however, surges and huge spikes might be regular occurrences.
A surge protector should more accurately be called “a thing that blocks excessive voltage when it exceeds a certain extreme point.” This cutoff, called clamping, is typically 330 volts (V), 400V, or 500V. While 330V or above might seem high compared to the 120V nominally delivered in the U.S., it’s not really that out of whack. Alternating current (AC) voltage centers around 120V, but it cycles or alternates from -170V through 0V to +170V and back again; 120V is the rough average.
Electronics and all other electrically powered anything for a home or office can accept brief amounts of much higher maximum voltages, which you can logically determine must be true as modest surges are routine and electronic equipment in homes isn’t constantly failing without a surge protector; it’s the big surges that need to be blocked.
Surge protectors of the category we tested use metal oxide varistors (MOVs), a kind of circuitry that absorbs voltages above the clamping level and effectively burn away over time. In an area with erratic voltage, your surge protector might wear out in months or a few years; on other electrical systems, it might last indefinitely. (There’s a much more expensive type of surge protector designed for high-end audio and very expensive electronics. It costs about ten times as much and it effectively never burns out.)
You don’t get full protection from an electrical strike with a surge protector: a strike near your home can exceed any consumer’s device’s ability to block the expended energy, though a circuit breaker on some models might trigger first. If you’re concerned about electrical strikes, you need to upgrade how the electrical feed comes into your house (or convince a landlord to do the same). But electrical strikes miles away can induce smaller surges that protectors will absorb.
Some surge protectors include telephone and coaxial pass-through connections for protecting DSL and cable-/satellite-TV connections. Industry reports and testing indicates these protections are effectively pointless, so we didn’t consider their presence or absence in our testing and reviews.
You can compare surge protectors’ durability, or the period over which the MOVs will remain effective, by looking at the number of joules advertised for the product. Joules measure how much energy is expended; the more joules, the more energy. So in an exactly equal situation in the same house with routine surges, a unit rated for 1000 joules should last half as long as one rated at 2000 joules.
In practice, this is very, very hard to determine. MOVs don’t degrade in a perfect linear fashion, and not all MOVs are of the same quality. Joules provide a rough basis of comparison that’s nearly impossible to test in lab conditions, as you’d have to simulate a variety of surges over long periods of time with multiple identical units of each model. That’s what manufacturers do in designing and testing their products. Certification from Underwriters Laboratories (UL) provides assurance that the product has been independently tested.
We’ll use joules as a rough rule of thumb, as it tends to parallel differences in price and other features, too. But when the MOVs burn out, what happens next?
Surge protectors don’t last forever
I’m about to blow your mind—or at least the minds of most people. If you have a surge protector already in place somewhere in your house or office, go take a quick glance at it and come back. Now, without looking again, is the “protection” light still lit? Can’t tell me? That’s a problem.
Older surge protectors were typically designed around the concern that computers had spinning hard disk drives (HDDs) inside, and that it was better to lose surge protection and keep providing power than to drop AC power when protection had failed. On surge protectors like that, the only indication of whether protection remains active is a protection light.
If the light isn’t lit, the MOVs have burned out, and there’s no protection left.
Now go back and look at those protectors again: which ones are burned out? Those are the ones you want to replace post haste. I confess that I only learned this in 2016; I checked mine, and had to replace one a few months later when that light suddenly disappeared.
That’s the biggest choice you’ll face, and we consider it in all the surge protectors we review. But there are three variants when protection fails:
All power stops flowing, which will immediately remove electricity to all connected devices. With SSDs or streaming audio/video equipment or a Blu-Ray or other disc player, that’s not a big deal. Better to lose power than to let a surge through.
Some power stops flowing. There are three different paths for electricity with AC power, and one is more important to protect against surges than the other two. (See below for more detail.) Some protectors thus only stop power passing through if that critical juncture’s MOVs die. You have to look at the protection light to know the state of protection.
Power always flows, but the light turns off. In this scenario, you must stay alert, particularly during a storm and right afterwards, or whenever your lights flicker .
AC power has three “legs” over which power passes. With a three-wire outlet, which is required for surge protectors, those are line, neutral, and ground. Power comes in over line, passes through neutral, and cycles through negative and positive voltage; that’s one leg (known as L-N).
There’s also a leg each from line to ground (L-G) and neutral to ground (N-G), which prevent a short circuit in the wiring from causing a fire or an explosion. A proper ground wire in an outlet connects back to a grounding rod for an entire home or building that drains voltage literally to the earth.
The Charg 3in1 is an exception to the rule that no surge protector will last forever: It has a replacement surge-protection module.
Does a warranty add value to a surge protector?
Many surge protector manufacturers offer limited warranties for damage to things plugged into the protector if said damage stems from voltage passing through to the device. These warranties (we’ve seen them offer anywhere from $20,000 to $300,000 in coverage), however, have so many provisos and exclusions—including having to apply for coverage within 15 or 30 days of damage with some, proving the right electrical setup, and providing receipts for all damaged goods—that the odds of meeting all the terms and collecting seem low. We’ve provided a sentence about warranties in each review, just so you’re informed, but don’t count on collecting unless you’re a good record keeper.
One last detail: a long power cord—at least 8 feet—is a must with a surge protector. That’s because for safety and power load, you must plug your surge protector directly into a wall socket, not into another surge protector, power strip, or uninterruptible power supply. Because you can plug so much power into a multi-outlet device, it’s very easy to overload the thing into which you’re “daisy chaining” the surge protector, which can cause product failure or even an electrical fire.
Don’t use a 3-to-2 prong adapter with a surge protector
You also must plug a surge protector into a properly grounded 3-prong outlet. You can use one of those clever 3-to-2 adapters that I know too well as the owner of an old house, in which only about half the outlets were ever upgraded to modern standards. Don’t know if your outlet is properly grounded? Some of the surge protectors have an LED that lights up if it’s not, or you can purchase a cheap plug-in detector from a hardware store. If you find your house isn’t grounded, call an electrician immediately; it’s a hazard. Fortunately, it can be cheap to fix unless the house was badly wired.
If you don’t follow the guidelines spelled out for plugging your surge protector into the wall, you can damage it void the product warranty and any damaged-items protection that comes with it.